Does your Lexmark printer show a “Replace Imaging Unit” or “Imaging Unit Low” message? Before you spend money on an expensive new 50F0Z00 unit, you should know that these components can often be serviced and recycled. A common issue is the accumulation of waste toner inside the unit, which can lead to gray backgrounds or streaks on your prints.
In this guide, we will show you how to professionally disassemble and clean the Lexmark 50F0Z00 Imaging Unit to extend its life and maintain perfect print quality.
Watch the Step-by-Step Recycling Video
Cleaning an imaging unit is a delicate process. Watch our full video guide to see how to handle the OPC drum and developer section:
⚠️ Disclaimer: Imaging units are extremely sensitive to light and physical damage. Handling toner requires protection (mask and gloves). Gimik.bg is not responsible for any damage to your unit or printer. Proceed at your own risk.
Compatible Printer Models
The Lexmark 50F0Z00 imaging unit is compatible with a wide range of MS and MX series printers:
- Lexmark MS Series: MS310, MS312, MS315, MS317, MS410, MS415, MS417, MS510, MS517, MS610, MS617
- Lexmark MX Series: MX310, MX317, MX410, MX417, MX510, MX511, MX517, MX610, MX611
When to Service the 50F0Z00 Unit?
- Your prints have a gray background or vertical streaks.
- The printer reports that the imaging unit has reached its end of life.
- You see toner leaking from the unit.
Step-by-Step Recycling Instructions
Step 1: Removing the OPC Drum
Carefully remove the side springs and screws to separate the OPC drum (the green cylinder) from the main housing. Crucial: Store the drum in a dark place or cover it with a cloth. Exposure to room light for more than a few minutes can permanently damage it.
Step 2: Cleaning the Waste Toner Bin
The main reason for failure is the waste toner compartment becoming full. Carefully empty all the old toner. Use a dedicated toner vacuum or compressed air to ensure the cleaning blade area is perfectly clean.
Step 3: Reassembly and Reset
Reassemble the unit in reverse order. To clear the “Replace” error, you will need to install a new 500Z reset chip on the side of the unit, as the printer tracks the page count via this chip.
🛒 Recommended Tools & Supplies
To complete this repair successfully, we recommend using these specific parts:
New OPC Drum for Lexmark 50F0Z00
Protective Mask and Gloves Set
Toner Vacuum (Optional but Recommended)
As an Amazon Associate, I earn from qualifying purchases. This post contains affiliate links.
Conclusion
Recycling your Lexmark 50F0Z00 imaging unit is not only environmentally friendly but also a massive cost-saver. With proper cleaning and a new chip, your unit can often perform just as well as a brand-new one.
For more professional printer repair guides and technical tips, visit Gimik.bg!