Looking for a way to reduce your printing costs for your HP LaserJet Pro M203 or MFP M227? Refilling your HP CF230A (30A) toner cartridge is a fast and cost-effective solution. With the right tools and a bit of patience, you can maintain professional print quality while saving a significant amount of money.
In this guide, we will show you the professional way to disassemble, clean, and refill your HP 30A cartridge without damaging the sensitive components.
Watch the Step-by-Step Refill Video
Before starting, watch our detailed video tutorial to see the exact locations of the clips and covers:
⚠️ Disclaimer: Refilling toner cartridges and repairing printers involves handling fine chemical powder and delicate electronic parts. Always wear a protective mask and gloves. Gimik.bg is not responsible for any damage to your equipment or health. Proceed at your own risk.
Compatible Printer Models
The HP CF230A (30A) cartridge is widely used in the following HP LaserJet Pro series:
- HP LaserJet Pro: M203d, M203dn, M203dw
- HP LaserJet Pro MFP: M227fdn, M227fdw, M227sdn
Important: A Note on the Reset Chip
Unlike some older HP models, the CF230A uses a smart chip. If your printer shows a “Toner Low” or “Replace Toner” message, you can usually continue printing, but for the most accurate results, we recommend replacing the chip during the refill process. Note: While the model number CF230A is the same globally, always ensure you are purchasing the correct version for your printer’s region.
Step-by-Step Refill Instructions
Step 1: Disassembling the Side Cover
The most critical part of this refill is removing the side cover without breaking the plastic clips. Use a small flat-head screwdriver to gently pry the cover open. Be careful not to apply too much force.
Step 2: Cleaning the Waste Toner (Optional but Recommended)
While the 30A design is efficient, cleaning the internal rollers and the developer area with compressed air or a toner vacuum ensures that your new toner won’t mix with old residue, preventing ghosting or streaks.
Step 3: Refilling the Toner Hopper
Locate the fill port (or the developer roller opening). Carefully pour in the high-quality replacement toner powder. For the CF230A, the standard fill is approximately 50-60 grams for a 1,600-page yield.
Step 4: Reassembly and Chip Replacement
Slide the developer roller back into place and snap the side cover back on. If you have a replacement chip, remove the old one using tweezers and slide the new one into the slot.
🛒 Recommended Supplies & Tools
Check the current prices for these verified cartridges and essential tools:
New HP 30A (CF230A) Toner Cartridge
Compatible HP 30X High Yield (CF230X)
Precision Screwdriver Set (for electronics)
Toner Vacuum or Compressed Air Duster
As an Amazon Associate, I earn from qualifying purchases. This post contains affiliate links.
Conclusion
Refilling the HP CF230A (30A) is a straightforward process that anyone can do at home or in the office. By following these steps, you not only save money but also reduce electronic waste.
For more professional printer repair guides and toner recycling tips, visit Gimik.bg!